Multiple Image Service
D-Link Unified Wired and Wireless Access System
Oct. 2015 Page 177
D-Link UWS User Manual
Figure 89: Multiple Image Service
The Active Image page contains the following fields:
• Click Activate to make the image that is selected in the Image Name field the next active image for
subsequent reboots.
• Click Delete to remove the selected image from permanent storage on the switch.You cannot delete the
active image.
• Click Change to update the image description on the switch.
• If the file you uploaded contains the boot loader code only, click Update Bootcode.
Table 77: Multiple Image Service Fields
Field Description
Image Name Select Active or Backup from the menu to activate on the next reload or to be deleted.
Current-active Displays name of current active image.
Next-active Displays the name of the image that is set to be active the next time the switch reloads.
Image
Description
If desired, enter a descriptive name for the respective Active or Backup software images.
Note: After activating an image, you must perform a system reset of the switch in order to run the
new code.
To Next Page
Loading...
