D-Link DWL-2600AP User Manual

Ping Test
D-Link Unified Wired and Wireless Access System
Oct. 2015 Page 95
D-Link UWS User Manual
Ping Test
Use the Ping page to tell the switch to send a Ping request to a specified IP address. You can use this feature
to check whether the switch can communicate with a particular network host.
To access the Ping page, click LAN > Administration > Ping Test in the navigation menu.
Figure 28: Ping
• Click Submit to send the ping. If successful, the results display as shown in Figure 29.
Table 23: Ping Fields
Field Description
Hostname/IP Address Enter the IP address or the host name of the station you want the switch to
ping. The initial value is blank. This information is not retained across a power
cycle.
Count Specify the number of pings to send.
Interval Specify the number of seconds between pings sent.
Size Specify the size of the ping packet to send.
Ping Displays the results of the ping.

D-Link DWL-2600AP Specifications

General

Networking standards	IEEE 802.3af
Ethernet LAN data rates	10, 100 Mbit/s
Maximum data transfer rate	300 Mbit/s
Internal	Yes
LED indicators	Power, Stand-by, Status, WAN, WLAN
WAN connection	Ethernet (RJ-45)
Ethernet LAN (RJ-45) ports	1
Security algorithms	WEP, WPA, WPA2
Operating temperature (T-T)	0 - 40 °C
Operating relative humidity (H-H)	10 - 90 %

Weight and Dimensions

Width	160 mm
Height	45 mm
Weight	240 g
Dimensions (WxDxH)	160 x 160 x 45 mm