D-Link DWL-2600AP User Manual

TraceRoute
D-Link Unified Wired and Wireless Access System
Oct. 2015 Page 96
D-Link UWS User Manual
TraceRoute
You can use the TraceRoute utility to discover the paths that a packet takes to a remote destination.
To display this page, click LAN > Administration > TraceRoute in the navigation tree.
Figure 29: TraceRoute
• Click Submit to initiate the traceroute. The results display in the TraceRoute box.
Table 24: TraceRoute Fields
Definition
Hostname/IP Address Enter the IP address or the hostname of the station you want the switch to discover
path for.
Probes Per Hop Enter the number of times each hop should be probed.
MaxTTL Enter the maximum time-to-live for a packet in number of hops.
InitTTL Enter the initial time-to-live for a packet in number of hops.
MaxFail Enter the maximum number of failures allowed in the session.
Interval Enter the time between probes in seconds.
Port Enter the UDP destination port in probe packets.
Size Enter the size of probe packets.
TraceRoute Displays the output from a traceroute.

D-Link DWL-2600AP Specifications

General

Networking standards	IEEE 802.3af
Ethernet LAN data rates	10, 100 Mbit/s
Maximum data transfer rate	300 Mbit/s
Internal	Yes
LED indicators	Power, Stand-by, Status, WAN, WLAN
WAN connection	Ethernet (RJ-45)
Ethernet LAN (RJ-45) ports	1
Security algorithms	WEP, WPA, WPA2
Operating temperature (T-T)	0 - 40 °C
Operating relative humidity (H-H)	10 - 90 %

Weight and Dimensions

Width	160 mm
Height	45 mm
Weight	240 g
Dimensions (WxDxH)	160 x 160 x 45 mm