D-Link DWL-2600AP User Manual

Booting the Switch
D-Link Unified Wired and Wireless Access System
Oct. 2015 Page 54
D-Link UWS User Manual
Update Boot Code
Use option 8 to update the boot code in the flash memory. This option is only valid after loading new boot code
using Boot Menu option 4. User action is confirmed with a Y/N question before executing the command.
To download software from the Boot menu:
1. On the Boot menu, select 8 and press <Enter>.
The following prompt displays:
Do you wish to update Boot Code? (y/n) y
Erasing Boot Flash.....Done.
Wrote 0x10000 bytes.
Wrote 0x20000 bytes.
Wrote 0x30000 bytes.
Wrote 0x40000 bytes.
Wrote 0x50000 bytes.
Wrote 0x60000 bytes.
Boot code updated
2. The bootup process resumes.
Delete Operational Code
Use option 9 to delete the active image from the flash memory. User action is confirmed with a Y/N question
before executing the command.
To delete the backup image from the Boot menu:
1. On the Boot menu, select 8 and press <Enter>.
The following prompt displays:
Are you SURE you want to delete operational code : image2 ? (y/n):y
Operational code deleted...
[Boot Menu]
2. The bootup process resumes.

D-Link DWL-2600AP Specifications

General

Networking standards	IEEE 802.3af
Ethernet LAN data rates	10, 100 Mbit/s
Maximum data transfer rate	300 Mbit/s
Internal	Yes
LED indicators	Power, Stand-by, Status, WAN, WLAN
WAN connection	Ethernet (RJ-45)
Ethernet LAN (RJ-45) ports	1
Security algorithms	WEP, WPA, WPA2
Operating temperature (T-T)	0 - 40 °C
Operating relative humidity (H-H)	10 - 90 %

Weight and Dimensions

Width	160 mm
Height	45 mm
Weight	240 g
Dimensions (WxDxH)	160 x 160 x 45 mm