AP Management
D-Link Unified Wired and Wireless Access System
Oct. 2015 Page 581
D-Link UWS User Manual
To apply proposed channel changes, click Apply.
It is possible for the network configuration to change between the time the automatic channel selection runs
and the time you attempt to apply the proposed channel assignments.
The channel will fail to be applied to an AP if one of the following conditions exist:
• The AP has failed.
• The radio on the AP has been disabled through a profile update.
• The channel is not valid for the radio mode.
• The AP has been rebooted since the channel plan was computed and acquires a static channel that has
been set statically via local database.
• The channel has been set manually through the advanced page.
• The auto-channel mode has been disabled in the profile for this AP.
Command Buttons
The page includes the following buttons:
• Apply—Apply the proposed channel change to the AP and change the current channel to the new
channel.
• Clear—Clear the proposed channel plan information.
• Refresh—Updates the page with the latest information.
• Start—Initiate the channel plan algorithm.
Table 340: Manual Channel Plan
Field Description
Current Status Shows the status of the plan, which is one of the following states:
• None: The channel plan algorithm has not been manually run since the last switch
reboot.
• Algorithm In Progress: The channel plan algorithm is running.
• Algorithm Complete: The channel plan algorithm has finished running. A table
displays to indicate proposed channel assignments. Each entry shows the AP
along with the current and new channel. To accept the proposed channel change,
click Apply. You must manually apply the channel plan for the proposed
assignments to be applied.
• Apply In Progress: The switch is applying the proposed channel plan and adjusting
the channel on the APs listed in the table.
• Apply Complete: The algorithm and channel adjustment are complete.
Proposed Channel Plan Entries
Note: If no APs appear in the table after the algorithm is complete, the algorithm does not recommend any
channel changes.
Current Channel Shows the current operating channel for the AP that the algorithm recommends for
new channel assignments.
New Channel Shows the proposed operating channel for the AP.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
