AP Management
D-Link Unified Wired and Wireless Access System
Oct. 2015 Page 587
D-Link UWS User Manual
Command Buttons
The page includes the following button:
• Refresh—Updates the page with the latest information.
Debugging the AP
You can enable debugging on an AP to allow Telnet access to the access point. Once you Telnet to the AP, you
can issue commands from the CLI to help you troubleshoot.
The fields in Table 344 on page 587 appear when you click the Debug link for a managed AP on the Managed
AP Advanced page.
Figure 375: Managed AP Debug
Power Click the Power link to access the Managed AP Channel/Power Adjust page. From
that page, you can set a new power level for the AP. The manual power change
overrides the power setting configured in the AP profile and is not retained when the
AP reboots or when the AP profile is reapplied. Table 345 on page 589 describes the
fields on the new page.
Table 344: Managed AP Debug
Field Description
MAC Address Shows the MAC address of the access point.
Location Shows the location of the access point, as configured in the Valid AP database.
IP Address Shows the IP address of the AP.
Status Shows the debug status, which can be one of the following:
• None: Debugging has not been enabled or disabled.
• Set Requested: A request has been made to change the debug status.
• Set Complete: Debugging has been enabled or disabled.
Password Enter the admin password for the AP (the default is admin).
Table 343: Advanced AP Management (Cont.)
Field Description
To Next Page
Loading...
Need help?
General
Weight and Dimensions
