D-Link DWL-2600AP User Manual

User Accounts
D-Link Unified Wired and Wireless Access System
Oct. 2015 Page 78
D-Link UWS User Manual
User Accounts
By default, the switch contains two user accounts:
• admin, with 'Read/Write' privileges
• guest, with 'Read Only' privileges
Both of these accounts have blank passwords by default. The names are not case sensitive.
If you log on to the switch with the user account that Read/Write privileges (i.e., as admin), you can use the
User Accounts page to assign passwords and set security parameters for the default accounts. You can also
add up to five read-only accounts. You can delete all accounts except for the Read/Write account.
To access the User Accounts page, click LAN > Administration > User Accounts in the navigation tree.
Figure 18: User Accounts
Note: Only a user with Read/Write privileges may alter data on this screen, and only one account can
exist with Read/Write privileges.

D-Link DWL-2600AP Specifications

General

Networking standards	IEEE 802.3af
Ethernet LAN data rates	10, 100 Mbit/s
Maximum data transfer rate	300 Mbit/s
Internal	Yes
LED indicators	Power, Stand-by, Status, WAN, WLAN
WAN connection	Ethernet (RJ-45)
Ethernet LAN (RJ-45) ports	1
Security algorithms	WEP, WPA, WPA2
Operating temperature (T-T)	0 - 40 °C
Operating relative humidity (H-H)	10 - 90 %

Weight and Dimensions

Width	160 mm
Height	45 mm
Weight	240 g
Dimensions (WxDxH)	160 x 160 x 45 mm