Basic Setup
D-Link Unified Wired and Wireless Access System
Oct. 2015 Page 550
D-Link UWS User Manual
The following table describes the fields you can configure from the Radio tab on the Basic Setup page. To
change the settings on this page, you must first select the radio you want to configure (1 or 2). After you
change the settings, click Submit to apply the settings. Changes to the settings apply only to the selected radio.
Table 328: Radio Settings
Field Description
1-802.11a
2-802.11b/g
From this field, you can select the radio that you want to configure. By default, Radio
1 operates in IEEE 802.11a mode, and Radio 2 operates in IEEE 802.11b/g mode. If
you change the mode, the labels for the radios change accordingly. Changes to the
settings apply only to the selected radio.
The DWL-3600AP is a single-radio AP. Any settings you configure for Radio 1
(802.11a) are not applied to the DWL-3600AP. If the selected Hardware Type ID for
the AP profile is DWL-3600AP, the radio selectors are not available.
State Specify whether you want the radio on or off by clicking On or Off.
If you turn off a radio, the AP sends disassociation frames to all the wireless clients it
is currently supporting so that the radio can be gracefully shutdown and the clients
can start the association process with other available APs.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
