EasyManuals Logo

D-Link DWL-2600AP User Manual

D-Link DWL-2600AP
754 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #217 background imageLoading...
Page #217 background image
Configuring IGMP Snooping
D-Link Unified Wired and Wireless Access System
Oct. 2015 Page 217
D-Link UWS User Manual
If you make any changes to the page, click Submit to apply the new settings to the system.
VLAN Status
Use the IGMP Snooping VLAN Status page to view information about the VLANs on the system that are
configured for IGMP snooping.
To access the IGMP Snooping VLAN Status page, click LAN > Monitoring> IGMP Snooping Status > VLAN
Status in the navigation tree.
Figure 122: IGMP Snooping VLAN Status
Operational Maximum
Response Time
This read-only field displays the value for maximum response time of IGMP
Snooping for the specified VLAN ID. Its value is learned dynamically from the
IGMPv2 or IGMPv3 queries received on this VLAN. For the multicast traffic not
to get disturbed, you should configure group membership interval to be
greater than this value.
Multicast Router Expiry Time Enter the amount of time in seconds that a switch waits for a query to be
received on an interface before the interface is removed from the list of
interfaces with multicast routers attached. The range is 0 to 3600 seconds. A
value of 0 indicates an infinite time-out; i.e., no expiration.
Table 106: IGMP Snooping VLAN Status Fields
Field Description
VLAN ID Displays the VLAN IDs for which the IGMP Snooping mode is Enabled.
Admin Mode Shows the IGMP Snooping Mode for the VLAN ID.
Fast Leave Admin Mode Indicates whether IGMP Snooping Fast-leave is active on the VLAN.
Group Membership Interval Shows the amount of time in seconds that a switch will wait for a report from
a particular group on a particular interface, which is participating in the VLAN,
before deleting the interface from the entry.
Max Response Time Shows the amount of time the switch waits after it sends a query on an
interface, participating in the VLAN, because it did not receive a report for a
particular group on that interface. This value may be configured.
Table 105: IGMP Snooping VLAN Configuration Fields (Cont.)
Field Description

Table of Contents

Other manuals for D-Link DWL-2600AP

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the D-Link DWL-2600AP and is the answer not in the manual?

D-Link DWL-2600AP Specifications

General IconGeneral
Networking standardsIEEE 802.3af
Ethernet LAN data rates10, 100 Mbit/s
Maximum data transfer rate300 Mbit/s
InternalYes
LED indicatorsPower, Stand-by, Status, WAN, WLAN
WAN connectionEthernet (RJ-45)
Ethernet LAN (RJ-45) ports1
Security algorithmsWEP, WPA, WPA2
Operating temperature (T-T)0 - 40 °C
Operating relative humidity (H-H)10 - 90 %
Weight and Dimensions IconWeight and Dimensions
Width160 mm
Height45 mm
Weight240 g
Dimensions (WxDxH)160 x 160 x 45 mm

Related product manuals