Configuring ARP
D-Link Unified Wired and Wireless Access System
Oct. 2015 Page 289
D-Link UWS User Manual
ARP Create
Use the ARP Create page to add an entry to the Address Resolution Protocol table.
To display the page, click LAN > L3 Features > ARP > ARP Create in the navigation tree.
Figure 184: ARP Create
• After you enter an IP address and the associated MAC address, click Submit to apply the changes to the
system and create the entry in the ARP table.
Table 167: ARP Create Fields
Field Description
IP Address Enter the IP address you want to add. It must be the IP address of a device on
a subnet attached to one of the switch's existing routing interfaces.
MAC Address The unicast MAC address of the device. Enter the address as six two-digit
hexadecimal numbers separated by colons, for example 00:06:29:32:81:40.
To Next Page
Loading...
