Configuring Global and Interface IP Settings
D-Link Unified Wired and Wireless Access System
Oct. 2015 Page 295
D-Link UWS User Manual
IP Interface Configuration
Use the IP Interface Configuration page to update IP interface data for this switch.
To display the page, click LAN > L3 Features > IP > Interface Configuration in the navigation tree.
Figure 188: IP Interface Configuration
Table 172: IP Interface Configuration Fields
Field Description
Interface Select the interface to configure from the dropdown menu. The dropdown
menu contains logical interfaces, including loopback interfaces and VLAN
routing interfaces.
Routing Interface Status Shows whether the IPv4 routing is up or down on the interface.
IP Address Configuration
Method
Specify whether the selected interface should receive an IP address
dynamically through DHCP, or statically through manual IP address
assignment.
If you configure DHCP as the method, additional buttons display at the bottom
of the page that allow you to renew, release, or display DHCP-assigned
information.
IP Address If the configuration method is manual, enter the static IP address for the
interface.
Subnet Mask If the configuration method is manual, enter the subnet mask for the
interface. This is also referred to as the subnet/network mask, and defines the
portion of the interface's IP address that is used to identify the attached
network.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
