D-Link DWL-2600AP User Manual

Configuring L2 Features
D-Link Unified Wired and Wireless Access System
Oct. 2015 Page 181
D-Link UWS User Manual
Section 4: Configuring L2 Features
Use the pages in the L2 Features navigation tree folder to configure the Layer 2 switching features available
on the D-Link DWS-4000 Series switch. The L2 Features folder contains links to the following features:
• “Configuring and Searching the Forwarding Database”
• “Managing VLANs”
• “Configuring Protected Ports”
• “Creating MAC Filters”
• “Configuring GARP”
• “Creating Port Channels (Trunking)”
• “Configuring IGMP Snooping”
• “Configuring IGMP Snooping Queriers”
• “Configuring MLD Snooping”
• “Configuring MLD Snooping Queriers”
• “Viewing Multicast Forwarding Database Information”
• “Configuring Spanning Tree Protocol”
• “Configuring DHCP Snooping”
• “Managing LLDP”
• “Configuring Dynamic ARP Inspection”

D-Link DWL-2600AP Specifications

General

Networking standards	IEEE 802.3af
Ethernet LAN data rates	10, 100 Mbit/s
Maximum data transfer rate	300 Mbit/s
Internal	Yes
LED indicators	Power, Stand-by, Status, WAN, WLAN
WAN connection	Ethernet (RJ-45)
Ethernet LAN (RJ-45) ports	1
Security algorithms	WEP, WPA, WPA2
Operating temperature (T-T)	0 - 40 °C
Operating relative humidity (H-H)	10 - 90 %

Weight and Dimensions

Width	160 mm
Height	45 mm
Weight	240 g
Dimensions (WxDxH)	160 x 160 x 45 mm