EasyManuals Logo

D-Link DWL-2600AP User Manual

D-Link DWL-2600AP
754 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #586 background imageLoading...
Page #586 background image
AP Management
D-Link Unified Wired and Wireless Access System
Oct. 2015 Page 586
D-Link UWS User Manual
Managed AP Advanced Settings
When the AP is in Managed mode, remote access to the AP is disabled. However, you can enable Telnet access
by enabling the Debug feature on the AP Management > Advanced Settings page. From the Managed AP
Advanced Settings page, you can also manually change the RF channel and power for each radio on an AP. The
manual power and channel changes override the settings configured in the AP profile (including automatic
channel selection) and take effect immediately. The manual channel and power assignments are not retained
when the AP is reset or if the profile is reapplied to the AP, such as when the AP disassociates and reassociates
with the switch.
Figure 374: Advanced AP Management
Each AP managed by the DWS-4000 Series switch is listed by its MAC address and location. The location is
based on the value in the RADIUS or local Valid AP database. Table 343 describes the Advanced features you
can configure for the AP.
Table 343: Advanced AP Management
Field Description
MAC Address Shows the MAC address of the AP.
Location Shows the AP location, which is based on the value configured in the RADIUS or local
Valid AP database.
Debug To help you troubleshoot, you can enable Telnet access to the AP so that you can
debug the device from the CLI.
The Debug field shows the debug status and can be one of the following:
Disabled
Set Requested
Set in Progress
Enabled
To change the status, click the Debug status link. The Managed AP Debug page
appears. Table 344 describes the fields on the new page.
Radio Identifies the radio to which the channel and power settings apply.
Channel Click the Channel link to access the Managed AP Channel/Power Adjust page. From
that page, you can set a new channel for Radio 1 or Radio 2. The available channels
depend on the radio mode and country in which the APs operate. The manual
channel change overrides the channel configured in the AP profile and is not retained
when the AP reboots or when the AP profile is reapplied.Table 345 on page 589
describes the fields on the new page.

Table of Contents

Other manuals for D-Link DWL-2600AP

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the D-Link DWL-2600AP and is the answer not in the manual?

D-Link DWL-2600AP Specifications

General IconGeneral
Networking standardsIEEE 802.3af
Ethernet LAN data rates10, 100 Mbit/s
Maximum data transfer rate300 Mbit/s
InternalYes
LED indicatorsPower, Stand-by, Status, WAN, WLAN
WAN connectionEthernet (RJ-45)
Ethernet LAN (RJ-45) ports1
Security algorithmsWEP, WPA, WPA2
Operating temperature (T-T)0 - 40 °C
Operating relative humidity (H-H)10 - 90 %
Weight and Dimensions IconWeight and Dimensions
Width160 mm
Height45 mm
Weight240 g
Dimensions (WxDxH)160 x 160 x 45 mm

Related product manuals