Monitoring Status and Statistics
D-Link Unified Wired and Wireless Access System
Oct. 2015 Page 487
D-Link UWS User Manual
Click the MAC address of the AP to view more information about the AP. If the AP is not a D-Link AP, some
values are unknown.
Command Buttons
The page includes the following buttons:
• Delete All—Delete the entries for all APs in the failure list.
• Manage—Add one or more selected APs from the Access Point Failure list to the Valid AP database.
• Refresh—Updates the page with the latest information.
Table 285: Access Point Authentication Failure Status
Field Description
MAC Address The Ethernet address of the AP. If the MAC address of the AP is followed
by an asterisk (*), it was reported by a peer switch.
IP Address The IP address of the AP.
Last Failure Type Indicates the last type of failure that occurred, which can be one of the
following:
• Local Authentication
• No Database Entry
• Not Managed
• RADIUS Authentication
• RADIUS Challenged
• RADIUS Unreachable
• Invalid RADIUS Response
• Invalid Profile ID
• Profile Mismatch-Hardware Type
• AP Relink
Age Time since failure occurred.
The AP failure status entries are collected at a point in time and
eventually age out. The age value for each entry shows how long ago the
switch recorded the entry. You can configure the age out time for status
entries on the WLAN > Administration > Advanced Configuration >
Global page. You can also manually delete status entries.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
