Basic Setup
D-Link Unified Wired and Wireless Access System
Oct. 2015 Page 539
D-Link UWS User Manual
Basic Setup
The WLAN > Administration > Basic Setup page contains several tabs that allow you to access Web pages to
configure global wireless settings for the DWS-4000 Series switch, device discovery settings, and default AP
profile settings. The Basic Setup page also provides a tab for access to pages to configure information in the
Valid AP Database on the switch. If AP MAC address validation is performed locally on the switch, and not by
a RADIUS server, the MAC address of the AP must be added to the Valid AP database to allow the switch to
manage the AP.
Wireless Global Configuration
In order for the DWS-4000 Series switch to be able to discover and manage access points, the WLAN admin
mode on the switch must be enabled, and the WLAN Switch Operational Status must report that it is enabled.
However, before you enable the WLAN Switch field, set the correct country code for the switch so that the
access points can operate only in the modes permitted in your country. The default country code is US for
operation in the United States. To set the country code, enable the switch by using the Web interface, and
configure other global wireless settings on the switch, click WLAN > Basic Setup.
Figure 356: Wireless Global Configuration
To Next Page
Loading...
Need help?
General
Weight and Dimensions
