System administration Configuration files
IX20 User Guide
1033
Log into the IX20 WebUI asa user with full Admin accessrights.
1. On the main menu, click System. Under Configuration, click Configuration Maintenance.
The Configuration Maintenance windowsisdisplayed.
2. In the Configuration Restore section:
a. If apassphrase was used to create the configuration backup, for Passphrase
(save/restore), enter the passphrase.
b. Under Configuration Restore, click Choose File.
c. Browse to the system firmware file location on your local computer and select the file.
d. Click RESTORE.
3. Click CONFIRM.
The configuration will be restored and the device will be rebooted.
Command line
1. Select the device in Remote Manager and click Actions> Open Console, or log into the IX20
local command line as a user with full Admin access rights.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to accessthe Admin CLI.
2. If the configuration backup is on a remote host, use scp to copy the file from the host to your
device:
> scp host hostname-or-ip user username remote remote-path local local-
path to local
where:
n
hostname-or-ip isthe hostname or IPaddress of the remote host.
n
username is the name of the user on the remote host.
n
remote-path isthe path and filename of the file on the remote host that will be copied
To Next Page
Loading...
Need help?
General