System administration Configure a power profile
IX20 User Guide
1024
Log into the IX20 WebUI asa user with full Admin accessrights.
1. On the menu, click System. Under Administration, click Find Me.
Anotification message appears, noting that the LEDis flashing on the device. Click the x in the
message to close it.
2. On the menu, click System again. Ablue circle next to Find Me is blinking, indicating that the
Find Me feature is active.
3. To deactivate the Find Me feature, click System and click Find Me again.
Anotification message appears, noting that the LEDis no longer flashing on the device. Click
the x in the message to close it.
Command line
1. Select the device in Remote Manager and click Actions> Open Console, or log into the IX20
local command line as a user with full Admin access rights.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to accessthe Admin CLI.
2. To activate the Find Me feature, at the prompt, type the following at the command prompt:
> system find-me on
>
3. To deactivate the Find Me feature, type the following at the command prompt:
> system find-me off
>
4. To determine the statusof the Find Me feature, type the following at the command prompt:
> system find-me status
off
>
Configure a power profile
Apower profile is a group of settings that determine how the system will behavein terms of power
consumption during standard operating mode. You can choose to preservepower, performance or to
balance both. You can also disable the IX20's LEDs to savepower and reduce light pollution.
To change the active power profile:
To Next Page
Loading...
Need help?
General