System administration EnableFIPSmode
IX20 User Guide
1027
n
528000
n
792000
The default is 792000.
5. Set leds_enabled to false to disable all LEDs on the device except for the Power LED, which
will remain lit green, indicating that the device has power:
(config)> system power leds_enabled false
(config)>
If disabled, one or more LEDs will flash periodically to indicate that the device is still active.
6. Save the configuration and apply the change
(config)> save
Configuration saved.
>
7. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.
Enable FIPS mode
You can enable your device to be Federal Information Processing Standard (FIPS) 140-2 compliant.
With FIPs 140-2 compliance, only FIPS140-2 cipher and MACalgorithmsare available. As a result,
features like stunnel, ssh, and openvpn are limited in what they can use. For example, in FIPSmode
ssh will only offer and negotiate AESbased ciphers.
When the FIPSsetting is changed, the device will reboot automatically. Disabling FIPSafter it has
been enabled will cause the current configuration to beerased.
Web
1. Log into Digi Remote Manager, or log into the local Web UI asa user with full Admin access
rights.
2. Access the device configuration:
Remote Manager:
a. Locate your device as described in Use Digi Remote Manager to view and manage your
device.
b. Click the Device ID.
c. Click Settings.
d. Click to expand Config.
Local Web UI:
To Next Page
Loading...