To Next Page

To Previous Page

Interfaces WideArea Networks(WANs)

IX20 User Guide

178

eth1 IPv6 up dhcp external eth1 1 10

eth2 IPv4 up static internal eth2 5 10

eth2 IPv6 up static internal eth2 5 10

loopback IPv4 up static loopback loopback 0 10

modem IPv4 up modem external wwan1 3 10

modem IPv6 down modem external wwan1 3 10

4. Enter show network interface name at the Admin CLI prompt to display additional

information about a specific WAN. For example, to display information about ETH1, enter show

network interface eth1:

> show network interface eth1

wan1 Interface Status

---------------------

Device : eth1

Zone : external

IPv4 Status : up

IPv4 Type : dhcp

IPv4 Address(es) : 10.10.10.10/24

IPv4 Gateway : 10.10.10.1

IPv4 MTU : 1500

IPv4 Metric : 1

IPv4 Weight : 10

IPv4 DNS Server(s) : 10.10.10.2, 10.10.10.3

IPv6 Status : up

IPv6 Type : dhcpv6

IPv6 Address(es) : fe00:2404::240:f4ff:fe80:120/64

IPv6 Gateway : ff80::234:f3ff:ff0e:4320

IPv6 MTU : 1500

IPv6 Metric : 1

IPv6 Weight : 10

IPv6 DNS Server(s) : fd00:244::1, fe80::234:f3f4:fe0e:4320

5. Type exit to exit the Admin CLI.

Depending on your device configuration, you may be presented with an Access selection

menu. Type quit to disconnect from the device.

Delete a WAN or WWAN

Follow thisprocedure to delete any WANs and WWANs that havebeen added to the system. You

cannot delete the preconfigured WAN, ETH1, or the preconfigured WWAN, Modem.

 Web

Digi IX20 User Manual

Questions and Answers: