Services Usethe MQTT broker service
IX20 User Guide
784
l
readwrite
l
write
The default is readwrite.
e. Add additional topics:
(config service mqtt topic_acl pattern 0)> add .. .. pattern end
(config service mqtt topic_acl pattern 1)>
f. Repeat the above stepsto set the topic and access type.
13. Save the configuration and apply the change
(config)> save
Configuration saved.
>
14. Typeexit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.
Show MQTT broker information
You can view statusand statistics about the MQTT broker from either the WebUI or the command line.
Web
Log into the IX20 WebUI asa user with full Admin accessrights.
1. On the main menu, click Status.
2. Under Services, click MQTT Broker.
Command line
Show MQTT broker information
1. Select the device in Remote Manager and click Actions> Open Console, or log into the IX20
local command line as a user with full Admin access rights.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to accessthe Admin CLI.
2. Use the show mqtt command at the system prompt:
> show location
MQTT Broker Status
------------------
Enabled : true
Status : up
Version : mosquitto version 2.0.14
Uptime : (202s)
To Next Page
Loading...
Need help?
General