Virtual PrivateNetworks(VPN) NEMO
IX20 User Guide
642
Current value:
(config vpn nemo nemo_example)> tun_local interface
ii. Set the interface. For example:
(config vpn nemo nemo_example)> tun_local interface eth1
(config vpn nemo nemo_example)>
The default is defaultroute.
13. Configure oneor more local networksto use asa virtual NEMOnetwork interface. Generally,
this will be a Local Area Network (LAN):
a. Add a local network to use asa virtual NEMOnetwork interface:
(config vpn nemo nemo_example)> add network end eth2
(config vpn nemo nemo_example)>
b. (Optional) Repeat for additional interfaces.
14. Save the configuration and apply the change
(config)> save
Configuration saved.
>
15. Typeexit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.
Show NEMO status
Web
Log into the IX20 WebUI asa user with full Admin accessrights.
1. On the menu, select Status> NEMO.
The NEMOpage appears.
2. To view configuration details about an NEMOtunnel, click the (configuration) icon in the
upper right of the tunnel's statuspane.
Command line
1. Select the device in Remote Manager and click Actions> Open Console, or log into the IX20
local command line as a user with full Admin access rights.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to accessthe Admin CLI.
2. To display details about all configured NEMOtunnels, typethe following at the prompt:
> show nemo
To Next Page
Loading...
Need help?
General