Routing Virtual Router Redundancy Protocol (VRRP)
IX20 User Guide
477
3. Set the DHCPserver gateway type to custom:
(config)> network interface eth2 ipv4 dhcp_server advanced gateway custom
(config)>
4. Set the custom gateway to 192.168.3.3:
(config)> network interface eth2 ipv4 dhcp_server advanced gateway_custom
192.168.3.3
(config)>
5. Save the configuration and apply the change
(config)> save
Configuration saved.
>
6. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.
Show VRRP statusand statistics
This section describeshow to display VRRP status and statistics for a IX20 device. VRRPstatusis
available from the Web UI only.
Web
1. Log into Digi Remote Manager, or log into the local Web UI asa user with full Admin access
rights.
2. Access the device configuration:
Remote Manager:
a. Locate your device as described in Use Digi Remote Manager to view and manage your
device.
b. Click the Device ID.
c. Click Settings.
d. Click to expand Config.
Local Web UI:
a. On the menu, click System. Under Configuration, click Device Configuration.
The Configuration window is displayed.
To Next Page
Loading...
Need help?
General