Services WAN bonding
IX20 User Guide
686
c. Open the CSV file in aspreadsheet editor (such asExcel).
The file consists key_type and key_value columns, used to identify the device that the
site-specific setting applies to, followed by columnsfor each setting that you designated
asRequire site specific settings.
n
key_type is either device_name or device_id.
n
key_value is either the device name, or the device ID, depending on the value of
key_type.
d. Include the username and password in the CSV file:
e. Save and close the CSV file.
f. In Remote Manager, click and select Upload. Select the edited CSVfile.
g. Click Continue.
5. For the Automation step in the configuration:
a. Toggle on Enable Scanning.
b. For Action Plan, toggle on Alert and Remediate.
c. Click Save.
6. To apply these configuration settings immediately to the devices linked to thisconfiguration
template, instead of waiting for the next automated scan and remediation to occur:
a. From theRemote Manager main menu, click Management > Configurations.
b. Select the configuration.
c. Click Actions> Scan Now.
Configure WAN bonding on your local device
Note WAN bonding support must be enabled in Digi Remote Manager. Contact your Digi sales
representativefor information.
You must also set up the WANbonding server. Thiscan be done using one of three mechanisms:
n
Set up a WAN bonding server on physical hardware or a Virtual Private Server (VPS) in your
local environment. See Bondix documentation for instructions.
n
Unwired Networks maintainsa number of WAN Bonding servers throughout the world, focused
mainly on locationsin the United States, Europe, and Australia. Contact them for WAN bonding
To Next Page
Loading...
Need help?
General