Interfaces Local Area Networks(LANs)
IX20 User Guide
202
eth2 IPv6 up static internal eth2 5 10
loopback IPv4 up static loopback loopback 0 10
modem IPv4 up modem external wwan1 3 10
modem IPv6 down modem external wwan1 3 10
>
4. Enter show network interface name at the Admin CLI prompt to display additional
information about a specific LAN. For example, to display information about ETH2, enter show
network interface eth2:
> show network interface eth2
lan1 Interface Status
---------------------
Device : eth2
Zone : internal
IPv4 Status : up
IPv4 Type : static
IPv4 Address(es) : 192.168.2.1/24
IPv4 Gateway :
IPv4 MTU : 1500
IPv4 Metric : 5
IPv4 Weight : 10
IPv4 DNS Server(s) :
IPv6 Status : up
IPv6 Type : prefix
IPv6 Address(es) : fd00:2704::1/48
IPv6 Gateway :
IPv6 MTU : 1500
IPv6 Metric : 5
IPv6 Weight : 10
IPv6 DNS Server(s) :
>
5. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.
Delete a LAN
Follow thisprocedure to delete any LANs that havebeen added to the system. You cannot delete the
preconfigured LAN, LAN1.
Web
1. Log into Digi Remote Manager, or log into the local Web UI asa user with full Admin access
rights.
To Next Page
Loading...
Need help?
General