System administration Erase device configuration and reset to factory defaults
IX20 User Guide
1021
3. At the config prompt, enter revert:
(config)> revert
(config)>
4. Set the password for the admin user prior to saving the changes:
(config)> auth user admin password pwd
(config)>
5. Save the configuration and apply the change
(config)> save
Configuration saved.
>
6. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.
Custom factory default settings
You can configure your IX20 device to use custom factory default settings. This way, when you erase
the device'sconfiguration, the device will reset to your custom configuration rather than to the
original factory defaults.
Required configuration items
n
Custom factory default file.
Configure the IX20 device to use custom factory default settings
Web
Log into the IX20 WebUI asa user with full Admin accessrights.
1. Configure your IX20 device to match the desired custom factory default configuration.
For example, you may want to configure the device to use a custom APN or a particular
network configuration, so that when you reset the device to factory defaults, it will
automatically have your required network configuration.
2. On the main menu, click System. Under Configuration, click Configuration Maintenance.
The Configuration Maintenance windowsisdisplayed.
To Next Page
Loading...
Need help?
General