To Next Page

To Previous Page

Serial port ConfigureModbusmode

IX20 User Guide

291

Asingle IPaddress or host name.

Anetwork designation in CIDRnotation, for example, 2001:db8::/48.

any: No limit to IPv6 addresses that can access the service-type.

iv. Click  again to list additional IPaddressesor networks.

To limit access to hosts connected through a specified interface on the IX20 device:

i. Click Interfaces.

ii. For Add Interface, click .

iii. For Interface, select the appropriate interface from the dropdown.

iv. Click  again to allow access through additional interfaces.

To limit access based on firewall zones:

i. Click Zones.

ii. For Add Zone, click .

iii. For Zone, select the appropriate firewall zonefrom the dropdown.

See Firewall configuration for information about firewall zones.

iv. Click  again to allow access through additional firewall zones.

d. Toggle on Enable mDNSto enable Multicast DNS(mDNS) reporting for thisservice. This

feature is disabled by default.

19. Expand Logging Settingsto configure logging for thisserial port.

a. To enable logging, click to toggle on Enable.

b. In the Log file name field, enter a descriptivename for the log file.

c. For Log file size, typethe size of the log file. When the log file reachesthe size limit, the

current file issaved and anew file is created. The default is 65536 bytes.

d. From the Type of data to log list box, specify the type of data that should be saved.

Received

Transmitted

Both

Both with arrows. This is the default.

e. If you want to log the time at which date wasreceived or transmitted, click the

Timestampstoggle to Enable.

f. If you want to log the data as hexadecimal values, click the Hexadecimal toggle to

Enable.

Note You can review the message log in the Serial Port Log page. See Review the serial

port message log.

20. Click Apply to save the configuration and apply the change.

Configure Modbusmode

Modbusmode allowsyou to use the serial port for Modbus. See Modbusgateway.

To change the configuration to match the serial configuration of the device to which you want to

connect:

 Web

Digi IX20 User Manual

Questions and Answers: