Services Location information
IX20 User Guide
732
(config service location geofence test_geofence on_exit
action 0)> sandbox false
(config service location geofence test_geofence on_exit
action 0)>
If you disable the sandbox, the script may render the system unusable.
vi. Repeat for any additional actions.
7. Save the configuration and apply the change
(config)> save
Configuration saved.
>
8. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.
Show location information
You can view statusand statistics about location information from either the WebUI or the command
line.
Web
Log into the IX20 WebUI asa user with full Admin accessrights.
1. On the main menu, click Status.
2. Under Services, click Location.
The device's current location isdisplayed, along with the statusof any configured geofences.
Command line
Show location information
1. Select the device in Remote Manager and click Actions> Open Console, or log into the IX20
local command line as a user with full Admin access rights.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to accessthe Admin CLI.
2. Use the show location command at the system prompt:
> show location
Location Status
---------------
State : enabled
Source : 192.168.2.3
Latitude : 44* 55' 14.809" N (44.92078)
Longitude : 93* 24' 47.262" w (-93.413128)
Altitude : 279 meters
To Next Page
Loading...
Need help?
General