Services Network Time Protocol
IX20 User Guide
761
dynamic_routes
edge
external
hotspot
internal
ipsec
loopback
setup
(config)>
Repeat thisstep to include additional firewall zones.
Note By default, the accesscontrol list for the NTPservice isempty, which meansthat all
downstream hosts connected to the IX20 device can use the NTPservice.
7. (Optional) Set the timezone for the location of your IX20 device. The default is UTC.
(config)> system time timezone value
(config)>
Where value is the timezone using the format specified with the following command:
(config)> system time timezone ?
Timezone: The timezone for the location of this device. This is used to
adjust the time for log
messages. It also affects actions that occur at a specific time of day.
Format:
Africa/Abidjan
Africa/Accra
Africa/Addis_Ababa
...
(config)>
8. Save the configuration and apply the change
(config)> save
Configuration saved.
>
9. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.
Show statusand statisticsof the NTP server
You can display statusand statistics for activeNTPservers
Web
To Next Page
Loading...
Need help?
General