Services Enable service discovery (mDNS)
IX20 User Guide
770
b. Disable the interfaces:
(config)> network interface eth1 enable false
(config)> network interface eth2 enable false
(config)>
In some cases, the device may bea part of a bridge, in which case you should remove the
device from the bridge.
See Configure a bridge for more information.
9. Save the configuration and apply the change
(config)> save
Configuration saved.
>
10. Typeexit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.
Enable service discovery (mDNS)
Multicast DNSmDNSisa protocol that resolveshost names in small networksthat do not have a DNS
server. You can enable the IX20 device to use mDNS.
Web
1. Log into Digi Remote Manager, or log into the local Web UI asa user with full Admin access
rights.
2. Access the device configuration:
Remote Manager:
a. Locate your device as described in Use Digi Remote Manager to view and manage your
device.
b. Click the Device ID.
c. Click Settings.
d. Click to expand Config.
Local Web UI:
a. On the menu, click System. Under Configuration, click Device Configuration.
The Configuration window is displayed.
To Next Page
Loading...
Need help?
General