Digi IX20 - Show L2 Tp Lns; Show L2 Tpeth; Show Location; Show Log

Command lineinterface Command linereference
IX20 User Guide
1174
Parameters
name: Display more details for a specific L2TPaccess concentrator.
show l2tp lns
Show L2TPnetwork server status& statistics.
Syntax
show l2tp lns [name STRING]
Parameters
name: Display more details for a specific L2TPnetwork server.
show l2tpeth
Show L2TPv3 ethernet tunnel session statusand statistics.
Syntax
show l2tpeth [name STRING]
Parameters
name: Display more details for a specific L2TPv3 ethernet tunnel session.
show location
Show location information.
Syntax
show location [geofence]
Parameters
geofence: Show geofence information.
show log
Show system log (low level).
Syntax
show log [number INTEGER] [filter <critical|warning|debug|info>]
Parameters
number: Number of lines to retrieve from log. (Minimum: 1, Default: 20)
filter: Filters for typeof log message displayed (critical, warning, info, debug). Note, filters from the
number of messagesretrieved not the whole log (this can be very time consuming). If you require
more messages of the filtered type, increase the number of messagesretrieved using 'number'.
show manufacture