To Next Page

To Previous Page

Firmwareconfiguration Usethelocal REST API to configuretheIX20 device

IX20 User Guide

Use the POST method to add itemsto a list array

To add itemsto a list array, use the POST method with the path and append parameters. For

example, to add the external firewall zone to the ssh service:

$ curl -k -u admin "https://192.168.210.1/cgi-

bin/config.cgi/value?path=service.ssh.acl.zone&append=true&value=external" -X

POST

Enter host password for user 'admin':

{ "ok": true, "result": "service.ssh.acl.zone.4" }

Use the POST method to add objectsto a list array

Objectsin an array that require one or more underlying values can be set using the collapsed URI

parameter. We recommend including the -g option as well, to instruct curl to turn off globbing. The

below example would add a new static route for the WAN interface for the 1.2.4.0/24 destination

network:

$ curl -g -k -u admin "https://192.168.210.1/cgi-

bin/config.cgi/value?path=network.route.static&append=true&collapsed

[dst]=1.2.4.0/24&collapsed[interface]=/network/interface/wan" -X POST

Enter host password for user 'admin':

{ "ok": true, "result": "network.route.static.1" }

Use the DELETEmethod to remove itemsfrom a list array

To remove items from a list array, use the DELETEmethod. For example, using curl:

$ curl -k -u admin "https://192.168.210.1/cgi-bin/config.cgi/value?path=path

where path is the path to the list item, including the list number, in dot notation (for example,

service.ssh.acl.zone.4).

For example, to remove the external firewall zone to the ssh service:

1. Use the GET method to determine the SSH service's list number for the external zone:

$ curl -k -u admin "https://192.168.210.1/cgi-

bin/config.cgi/value?path=service/ssh/acl/zone -X GET

{

"ok": true,

"result": {

"type": "array",

"path": "service.ssh.acl.zone"

, "collapsed": {

"0": "internal"

"1": "edge"

"2": "ipsec"

"3": "setup"

Digi IX20 User Manual

Questions and Answers: