EasyManua.ls Logo

Digi IX20 - Connect Data Cables; Mount the IX20 Device; Attach to a Mounting Surface by Using the Mounting Tabs; Attach to DIN Rail with Clip

Digi IX20
1188 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Hardwaresetup Connect data cables
IX20 User Guide
41
n
Move the device to another location.
n
Try connecting a different set of antennas, if available.
n
Purchase a Digi Antenna Extender Kit: Antenna Extender Kit, 1m.
Connect data cables
The IX20 supports two typesof data ports:
n
Ethernet (RJ-45): Use a Cat 5e or Cat 6 Ethernet cable.
n
Serial (9-pin RS-232): Use a serial cable with a 9-pin RS-232 connector.
Mount the IX20 device
There are three optionsfor mounting the IX20 device:
n
Attach to a mounting surface by using the mounting tabs.
n
Attach to DIN rail with clip.
n
Attach to DIN rail with bracket.
Attach to a mounting surface by using the mounting tabs
Attach to DIN rail with clip
The DIN rail clip isan optional accessory included when the IX20 ispurchased with accessories.

Table of Contents