Serial port Configure Remote Accessmode
IX20 User Guide
251
11. Configure serial port logging:
a. Enable serial port logging:
(config)>serial port1 logging enable true
(config)>
b. Set the file name:
(config)>serial port1 logging filename string
(config)>
c. Set the maximum allowed log size for the serial port log when starting the log:
(config)>serial port1 logging size value
(config)>
where value is the size of the log file in bytes. The default is 65536.
d. Specify the data type:
(config)>serial port1 logging type value
(config)>
where value is one of:
n
received
n
transmitted
n
both
n
arrows. Thisis the default.
e. Log the time at which date was received or transmitted:
(config)>serial port1 logging hex true
(config)>
f. Log data ashexadecimal values:
(config)>serial port1 logging timestamp true
(config)>
12. Save the configuration and apply the change
(config)> save
Configuration saved.
>
13. Typeexit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.
Configure Remote Access mode
Remote Accessmode allowsfor remote accessto another device that is connected to the serial port.
To Next Page
Loading...
Need help?
General