Command lineinterface Configuration mode
IX20 User Guide
1144
Parameters Current Value
-------------------------------------------------------------------------
-
enable true Enable
key [private] Private key
port 22 Port
Additional Configuration
-------------------------------------------------------------------------
-
acl Access control list
mdns
> config service ssh
4. Lastly, display the allowed values and other information for the enable parameter:
> config service ssh enable ?
Enable: Enable the service.
Format: true, false, yes, no, 1, 0
Default value: true
Current value: true
> config service ssh enable
Configuration mode
Configuration mode allowsyou to perform multiple configuration tasksand validate the changesprior
to saving them. You can cancel all changes without saving them at any time. Configuration changes
do not take effect until the configuration is saved.
Enable configuration mode
To enable configuration mode, at the root prompt, enter the config command without any
parameters:
> config
(config)>
When the command line is in configuration mode, the prompt will change to include (config), to
indicate that you are currently in configuration mode.
Enter configuration commandsin configuration mode
There are two ways to enter configuration commandswhile in configuration mode:
n
Enter the full command string from the config prompt.
For example, to disable the ssh service by entering the full command string at the config
prompt:
To Next Page
Loading...
Need help?
General