Virtual PrivateNetworks(VPN) OpenVPN
IX20 User Guide
563
8. Save the configuration and apply the change
(config)> save
Configuration saved.
>
9. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.
Configure an OpenVPN client without using an .ovpn file
Required configuration items
n
Enable the OpenVPNclient.
The OpenVPNclient is enabled by default.
n
The mode used by the OpenVPNserver, either routing (TUN), or bridging (TAP).
n
The firewall zone to beused by the OpenVPNclient.
n
The IPaddressof the OpenVPNserver.
n
Certificatesand keys:
l
The CAcertificate (usually in a ca.crt file).
l
The Public key (for example, client.crt)
l
The Private key (for example, client.key).
Additional configuration items
n
The route metric for the OpenVPNclient.
n
The login credentials for the OpenVPNclient, if configured on the OpenVPNserver.
n
Additional OpenVPN parameters.
See Configure SureLink activerecovery for OpenVPNfor information about OpenVPNactiverecovery.
Web
1. Log into Digi Remote Manager, or log into the local Web UI asa user with full Admin access
rights.
2. Access the device configuration:
Remote Manager:
a. Locate your device as described in Use Digi Remote Manager to view and manage your
device.
b. Click the Device ID.
c. Click Settings.
d. Click to expand Config.
Local Web UI:
To Next Page
Loading...
Need help?
General