Virtual PrivateNetworks(VPN) OpenVPN
IX20 User Guide
562
3. At the config prompt, type:
(config)> add vpn openvpn client name
(config vpn openvpn client name)>
where name is the name of the OpenVPNserver.
The OpenVPNclient is enabled by default. To disable the client, type:
(config vpn openvpn client name)> enable false
(config vpn openvpn client name)>
4. Set the firewall zone for the OpenVPNclient:
(config vpn openvpn client name)> zone value
(config vpn openvpn client name)>
To view a list of available zones:
(config vpn openvpn client name)> zone ?
Zone: The zone for the openvpn client interface.
Format:
any
dynamic_routes
edge
external
hotspot
internal
ipsec
loopback
setup
Current value:
(config vpn openvpn client name)>
5. (Optional) Set the route metric for the OpenVPNserver. If multiple active routes match a
destination, the route with the lowest metric will be used.
(config vpn openvpn client name)> metric value
(config vpn openvpn client name)>
where value is an interger between 0 and 65535. The default is 0.
6. (Optional) Set the login credentials asconfigured on the OpenVPNserver:
(config vpn openvpn client name)> username value
(config vpn openvpn client name)> password value
(config vpn openvpn client name)>
7. Paste the content of the client.ovpn file into the value of the config_file parameter:
(config vpn openvpn client name)> config_file value
(config vpn openvpn client name)>
To Next Page
Loading...
Need help?
General