Serial port Configure Modem emulator mode
IX20 User Guide
288
(config)>serial port1 logging size value
(config)>
where value is the size of the log file in bytes. The default is 65536.
d. Specify the data type:
(config)>serial port1 logging type value
(config)>
where value is one of:
n
received
n
transmitted
n
both
n
arrows. Thisis the default.
e. Log the time at which date was received or transmitted:
(config)>serial port1 logging hex true
(config)>
f. Log data ashexadecimal values:
(config)>serial port1 logging timestamp true
(config)>
17. Save the configuration and apply the change
(config)> save
Configuration saved.
>
18. Typeexit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.
Configure Modem emulator mode
Modem emulator mode allowsthe device to act as a dial-up modem emulator for handling incoming
AT dial-ins.
To change the configuration to match the serial configuration of the device to which you want to
connect:
Web
1. Log into Digi Remote Manager, or log into the local Web UI asa user with full Admin access
rights.
2. Access the device configuration:
Remote Manager:
a. Locate your device as described in Use Digi Remote Manager to view and manage your
device.
To Next Page
Loading...
Need help?
General