User authentication User authentication methods
IX20 User Guide
866
(config)> show auth method
0 local
(config)>
n
To add the new authentication method to the beginning of the list, use the index value
of 0 to indicate that it should be added as the first method:
(config)> add auth method 0 auth_type
(config)>
where auth_typeis one of local, radius, tacacs+, or ldap.
n
To add the new authentication method to the end of the list, use the index keyword
end:
(config)> add auth method end auth_type
(config)>
where auth_typeis one of local, radius, tacacs+, or ldap.
n
To add the new authentication in another location in the list, use an index value to
indicate the appropriate position. For example:
(config)> add auth method 1 auth_type
(config)>
where auth_typeis one of local, radius, tacacs+, or ldap.
n
You can also use the move command to rearrange existing methods. See Rearrange the
position of authentication methodsfor information about how to reorder the
authentication methods.
4. Save the configuration and apply the change
(config)> save
Configuration saved.
>
5. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.
Delete an authentication method
Web
1. Log into Digi Remote Manager, or log into the local Web UI asa user with full Admin access
rights.
2. Access the device configuration:
Remote Manager:
To Next Page
Loading...
Need help?
General