Wi-Fi Configure theWi-Fi radio'schannel
IX20 User Guide
314
Configure the Wi-Fi radio'schannel
By default, the Wi-Fi radio is configured to automatically select the best channel to use with respect to
other Wi-Fi networks. You can configure a specific channel to use for the Wi-Fi radio by using the
following steps.
n
2.4 GHz band—Channels1 to 11 are supported. Channels12, 13, and 14 are not supported.
n
5 GHz band—By default, only non-Dynamic Frequency Selection (DFS) channelsare supported.
You can also enable support for DFSchannels in client mode. See Configure the Wi-Fi radio to
support DFSchannelsin client modefor information about enabling DFSsupport.
Note Not all Digi devices currently support 5 GHz. Before you try to use this feature, verify that
your device supports5 GHz.
Web
1. Log into Digi Remote Manager, or log into the local Web UI asa user with full Admin access
rights.
2. Access the device configuration:
Remote Manager:
a. Locate your device as described in Use Digi Remote Manager to view and manage your
device.
b. Click the Device ID.
c. Click Settings.
d. Click to expand Config.
Local Web UI:
a. On the menu, click System. Under Configuration, click Device Configuration.
The Configuration window is displayed.
3. Click Network >WiFi.
To Next Page
Loading...
Need help?
General