Firmwareconfiguration Changethedefault SSIDand pre-shared key for thepreconfigured Wi-Fi accesspoint
IX20 User Guide
51
4. Save the configuration and apply the change
(config)> save
Configuration saved.
>
5. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.
Change the default SSID and pre-shared key for the
preconfigured Wi-Fi access point
For the Wi-Fi enabled IX20Wdevice, by default, the SSIDand pre-shared key for the preconfigured Wi-
Fi accesspoint are:
n
Enabled
n
SSID: Digi-IX20W-serial_number
n
Encryption: WAP2 Personal (PSK)
n
Pre-shared key: Theunique password printed on the bottom label of the device.
Note When Primary Responder mode isenabled, pre-configured accesspoints are enabled by default.
For more information about Primary Responder mode, see Differences between standard firmware
operation and Primary Responder mode.
Web
1. Log into Digi Remote Manager, or log into the local Web UI asa user with full Admin access
rights.
2. Access the device configuration:
Remote Manager:
a. Locate your device as described in Use Digi Remote Manager to view and manage your
device.
b. Click the Device ID.
c. Click Settings.
d. Click to expand Config.
Local Web UI:
a. On the menu, click System. Under Configuration, click Device Configuration.
The Configuration window is displayed.
To Next Page
Loading...
Need help?
General