Firmwareconfiguration Changethedefault password for theadmin user
IX20 User Guide
50
3. Click Authentication > Users>admin.
4. Enter a new password for the admin user. Thepassword must be at least eight characters long
and must contain at least oneuppercase letter, one lowercase letter, one number, and one
special character.If the primary responder feature is enabled, the password must be at least 10
characters long and must contain at least one uppercase letter, one lowercase letter, one
number, and one special character.
5. Click Apply to savethe configuration and apply the change.
Command line
1. Select the device in Remote Manager and click Actions> Open Console, or log into the IX20
local command line as a user with full Admin access rights.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to accessthe Admin CLI.
2. At the command line, type config to enter configuration mode:
> config
(config)>
3. Set a new password for the admin user. The password must be at least eight characters long
and must contain at least oneuppercase letter, one lowercase letter, one number, and one
special character.If the primary responder feature is enabled, the password must be at least 10
characters long and must contain at least one uppercase letter, one lowercase letter, one
number, and one special character.
(config)> auth user admin password new-password
(config)>
To Next Page
Loading...
Need help?
General