EasyManuals Logo

Digi IX20 User Manual

Digi IX20
1188 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #318 background imageLoading...
Page #318 background image
Wi-Fi ConfiguretheWi-Fi radio'sband and protocol
IX20 User Guide
318
b. Enable DFSclient support :
(config)> network wifi radio phy0 5000mhz dfs_client true
(config)>
Note When DFS client support is enabled, any enabled accesspoints that use this radio
will not be started and cannot be used as accesspoints.
4. Save the configuration and apply the change
(config)> save
Configuration saved.
>
5. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.
Configure the Wi-Fi radio'sband and protocol
For Wi-Fi radios that support both 2.4 GHz and 5 GHz modes, you can configure the band. Wi-Fi radio
defaultsto use 2.4 GHzb/g/n band
Note Not all Digi devices currently support 5 GHz. Before you try to use this feature, verify that your
device supports5 GHz.
Web
1. Log into Digi Remote Manager, or log into the local Web UI asa user with full Admin access
rights.
2. Access the device configuration:
Remote Manager:
a. Locate your device as described in Use Digi Remote Manager to view and manage your
device.
b. Click the Device ID.
c. Click Settings.
d. Click to expand Config.
Local Web UI:
a. On the menu, click System. Under Configuration, click Device Configuration.
The Configuration window is displayed.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Digi IX20 and is the answer not in the manual?

Digi IX20 Specifications

General IconGeneral
CategoryWireless Router
Cellular Connectivity4G LTE
Ethernet Ports4
Wi-Fi802.11ac
SIM Slots2
WAN Ports1
LAN Ports3
Weight0.5 kg
Operating Temperature-40°C to +70°C (-40°F to +158°F)