Central management Configureyour device for Digi Remote Manager support
IX20 User Guide
73
bytes
enable true
serial
rx
bytes
enable true
tx
bytes
enable true
cellular
1
rx
bytes
enable true
packets
enable true
...
(config)>
To disable a tuning parameter, set itsvalue to false. For example, to turn off all reporting for
the serial port:
(config)> monitoring devicehealth tuning all serial rx bytes enabled
false
(config)> monitoring devicehealth tuning all serial tx bytes enabled
false
(config)>
7. Save the configuration and apply the change
(config)> save
Configuration saved.
>
8. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.
Enable event log upload to Digi Remote Manager
You can configure your device to upload the event log to Digi Remote Manager, and configure the
interval between event log uploads.
To enable the event log upload, or disable it if it has been disabled, and to change the upload interval:
Web
1. Log into Digi Remote Manager, or log into the local Web UI asa user with full Admin access
rights.
2. Access the device configuration:
Remote Manager:
To Next Page
Loading...
Need help?
General