System administration Configurethe speed of your Ethernet ports
IX20 User Guide
1043
2. Connect the PC's Ethernet port to the ETH1 Ethernet port on your IX20 device.
3. Open a telnet session and connect to the IX20 device at the IPaddress of 192.168.210.1.
4. Log into the device:
n
Username: admin
n
Password: The default unique password for your device is printed on the device label.
5. At the shell prompt, type:
# rm /etc/config/.nocrypt
# flatfsd -i
This will re-enable encryption and leave the device at its factory default setting.
Configure the speed of your Ethernet ports
You can configure the speed of your IX20 device's Ethernet ports.
Web
To Next Page
Loading...