Services Location information
IX20 User Guide
704
(config)> service location interval 600s
(config)>
The default is 10 seconds.
5. Save the configuration and apply the change
(config)> save
Configuration saved.
>
6. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.
Enable or disable modem GNSS support
Note Modem GNSSsupport is currently only available with the CM07 CORE modem.
The IX20 device supports the CM07 CORE modem, which providesa GNSSmodule to determine the
device's location.
To disable support for the modem's GNSSreceiver, or enable it if it has been disabled:
Web
1. Log into Digi Remote Manager, or log into the local Web UI asa user with full Admin access
rights.
2. Access the device configuration:
Remote Manager:
a. Locate your device as described in Use Digi Remote Manager to view and manage your
device.
b. Click the Device ID.
c. Click Settings.
d. Click to expand Config.
Local Web UI:
a. On the menu, click System. Under Configuration, click Device Configuration.
The Configuration window is displayed.
To Next Page
Loading...
Need help?
General