Services Location information
IX20 User Guide
705
3. Click Services> Location > Location sources>modem.
4. (Optional) Type a Label for the Modem GNSS location source.
5. For Type of location source, leave the selection at Modem GNSS.
6. Click Enable the location source to disable the GNSS receiver, or to enable it if it has been
disabled.
7. Alternatively, you can also delete the modem location source:
a. Click the menu icon (...) next to the modem location source.
b. Click Delete.
8. Click Apply to savethe configuration and apply the change.
Command line
1. Select the device in Remote Manager and click Actions> Open Console, or log into the IX20
local command line as a user with full Admin access rights.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to accessthe Admin CLI.
2. At the command line, type config to enter configuration mode:
> config
(config)>
3. Enable or disable the modem GNSS module:
a. Use the show command to determine the index number of the modem GNSS location
source:
(config)> show service location source
0
enable true
no label
To Next Page
Loading...
Need help?
General