User authentication LDAP
IX20 User Guide
906
default value is used:
n
If you are accessing the IX20 device by using the WebUI, the default value is for NAS ID is
httpd.
n
If you are accessing the IX20 device by using ssh, the default value is sshd.
(config)> auth radius nas_id id
(config)>
6. Add a RADIUSserver:
a. Add the server:
(config)> add auth radius server end
(config auth radius server 0)>
b. Enter the RADIUSserver's IPaddress or hostname:
(config auth radius server 0)> hostname hostname|ip-address
(config auth radius server 0)>
c. (Optional) Change the default port setting to the appropriate port:
(config auth radius server 0)> port port
(config auth radius server 0)>
d. Configure the amount of time in secondsto wait for the RADIUSserver to respond. Allowed
value is any integer from 3 to 60. The default value is 3.
(config auth radius server 0)> timeout value
(config auth radius server 0)>
e. (Optional) Repeat the above steps to add additional RADIUSservers.
7. Add RADIUSto the authentication methods. Authentication methodsare attempted in the
order they are listed until the first successful authentication result isreturned. Thisexample
will add RADIUSto the end of the list. See User authentication methodsfor information about
adding methodsto the beginning or middle of the list.
(config)> add auth method end radius
(config)>
8. Save the configuration and apply the change
(config)> save
Configuration saved.
>
9. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.
LDAP
Your IX20 device supportsLDAP(Lightweight Directory Access Protocol), a protocol used for directory
information servicesover an IPnetwork. LDAPcan beused with your IX20 device for centralized
To Next Page
Loading...
Need help?
General