Interfaces Virtual LANs(VLANs)
IX20 User Guide
231
Create a VLAN using switchport mode
Required configuration items
n
Device to beassigned to the VLAN.
n
The VLAN ID. The TCPheader usesthe VLAN IDto identify the destination VLAN for the packet.
To create a VLAN using switchport mode:
Web
1. Log into Digi Remote Manager, or log into the local Web UI asa user with full Admin access
rights.
2. Access the device configuration:
Remote Manager:
a. Locate your device as described in Use Digi Remote Manager to view and manage your
device.
b. Click the Device ID.
c. Click Settings.
d. Click to expand Config.
Local Web UI:
a. On the menu, click System. Under Configuration, click Device Configuration.
The Configuration window is displayed.
3. Click Network >Bridges.
4. For Add Bridge, typea name for the bridge and click .
5. Bridges are enabled by default. To disable, toggle off Enable.
6. For Bridge type, select Switchport.
7. (Optional) Enable Spanning Tree Protocol (STP).
STPis used when using multiple LANson the same device, to prevent bridge loopsand other
routing conflicts.