Command lineinterface Command linereference
IX20 User Guide
1188
src_addr: Chooses an alternative source address. Note that you must select the address of one of the
interfaces. By default, the address of the outgoing interface is used.
tos: For IPv4, set the Type of Service (ToS) and Precedence value. Useful values are 16 (low delay) and
8 (high throughput). Note that in order to use someTOSprecedence values, you have to be super
user. For IPv6, set the Traffic Control value. Avalue of -1specifies that no value will be used.
(Minimum: -1, Default: -1)
waittime: Determines how long to wait for aresponse to a probe. (Minimum: 1, Default: 5)
pausemsecs: Minimal time interval between probes. (Minimum: 0, Default: 0)
packetlen: Total size of the probing packet. Default 60 bytesfor IPv4 and 80 for Ipv6. Avalue of -1
specifies that the default value will be used. (Minimum: -1, Default: -1)
debug: Enable socket level debugging.
dontfragment: Do not fragment probe packets.
icmp: Use ICMPECHOfor probes.
nomap: Do not try to map IPaddressesto host nameswhen displaying them.
bypass: Bypassthe normal routing tablesand send directly to a host on an attached network.
calibrate analog input ports
Calibrate the analog input ports(voltage-, and current-modeseparately) on a custom low and high set
point.
Syntax
ain
calibrate
<port>
low/high
<reference
voltage/current>
Parameters
port:
reference voltage/current: hasa minimum of 0
low|high
ain calibrate 12 low 0
ain calibrate 12 high 100
To Previous Page
Loading...