To Next Page

To Previous Page

Interfaces Show SureLink statusand statistics

IX20 User Guide

242

Depending on your device configuration, you may be presented with an Access selection

menu. Type admin to accessthe Admin CLI.

2. At the Admin CLI prompt, type:

> show surelink state

Test on network.interface.eth1.ipv6 with condition: one

dns_configured (n);

network.interface.eth1.ipv6; -> update_routing_table

ACTION ATTEMPTS STATUS

restart_interface 00/01 [FAILED]

update_routing_table 00/01

Test on network.interface.modem.ipv4 with condition: all

dns_configured (n);

network.interface.modem.ipv4; -> restart_interface

ACTION ATTEMPTS STATUS

update_routing_table 00/03 [ BUSY ]

restart_interface 00/03

reset_modem 00/03

switch_sim 00/03

modem_power_cycle 00/03

restart_interface 00/03

Show SureLink statusfor all interfaces

To show the SureLink status all interfaces, use the show surelink interface all command:

1. Select the device in Remote Manager and click Actions> Open Console, or log into the IX20

local command line as a user with full Admin access rights.

Depending on your device configuration, you may be presented with an Access selection

menu. Type admin to accessthe Admin CLI.

2. At the Admin CLI prompt, type :

> show surelink interface all

Interface Test Proto Last Response Status

--------- ----------------------------- ----- ------------- -------

eth1 Interface is up IPv4 32 seconds Passing

eth1 Interface's DNS servers (DNS) IPv4 28 seconds Passing

eth2 Interface is up IPv4 21 seconds Passing

eth2 Interface's DNS servers (DNS) IPv4 20 seconds Passing

modem Interface is up IPv4 115 seconds Passing

modem Interface's DNS servers (DNS) IPv4 114 seconds Passing

Digi IX20 User Manual

Questions and Answers: